Construction & Demolition Waste Recycling
Many homeowners and contractors may be surprised to hear that recycling options for certain construction materials and demolition "waste" exist in Vermont. Though recycling options are rapidly developing, this page will direct you to current recycling outlets, regulations, and Vermont-based resources and strategies for resource-conscious development.
Why recycle project components?
With some light planning and diligence, certain Construction and Demolition (C&D) waste materials can be separated from landfill wastes on your project site, and then recycled or salvaged into useful products or beautiful new structures. With more than 50,800 tons of waste generated anually from C&D projects in Vermont (accounting for 10% of residential waste and 15% of commercial waste), recycling or reusing project by-products across the State can make a large impact in resource conservation and mitigating landfill use.
- Clean Wood Landfill ban effective July 1, 2016
- Asphalt Shingles
- Scrap Metal
- Oriented Strand Board (OSB)
- Granite, slate, and other special fixtures or features may be re-purposed
*Materials listed in bold indicate a subset of construction waste materials deemed architectural waste materials. Under certain conditions, State law requires that projects keep these materials out of the trash and transferred to a recycling facility. Read more below.
Projects Required to Recycle Architectural Materials Under State Law (10 V.S.A. § 6605m.)
Some construction, deconstruction, or demolition projects are required to seperate architectural waste materials for the purpose of recycling. A project is subject to the requirement if it meets ALL of the following conditions:
The project produces 40 cubic yards or more of architectural waste. Forty cubic yards is the typical volume of one construction site roll-off dumpster.
The project site is within 20 miles of a solid waste facility that recycles architectural waste.
The construction or demolition project is for a commercial building or a residential building with 2 or more units.
Facilities Accepting Architectural Waste Materials for Recycling
The Rutland County Solid Waste District (RCSWD) Transfer Station located on Gleason Road in Rutland accepts construction and demolition debris at $140 per ton with a permit and $165 per ton without a permit. Construction and demolition materials can include couches and chairs. Clean wood is also accepted at $45 per ton with a permit and $55 per ton without a permit.
Concrete and Asphalt Facilities:
Markowski Construction, Pittsford, Vermont - concrete and asphalt - 802-483-6469
Wilk Paving - asphalt - 802-438-5454
RCSWD Transfer Station is accepting small loads (one-ton or less) of concrete and/or brick at $65 per ton.
There are also currently two facilities in Vermont that accept loads of architectural waste, in addition to other materials. Check with each facility for details.
All Cycle Transfer Station
220 Avenue B, Williston, VT 05495
Accepts loads of architectural waste for sorting and recycling, as well as municipal solid waste. Loads of 1 ton or more only. Call ahead.
There are many other facilities around the state that will accept single materials, such as concrete, brick, asphalt, or a combination of several types. To locate a certified solid waste facility, visit the Materials Management Map.
Other Businesses and Organizations Accepting Used Material
Beyond solid waste facilities certified by the Agency of Natural Resources, there is a wide array of building salvage, reuse, and antique stores that look for quality used building materials, fixtures, and appliances.